Atlantic WWCS2 Manuel Du Produit page 4

Maintenance
Replacement diode, gasket and lens kits are available for Spout Lights. Unplug the fixture. Loosen
the brass lens ring. Remove lens ring, lens and gasket. Carefully remove the diode assembly and
replace. Install new silicone gasket and lens and reassemble. Ensure that all components are
installed correctly after servicing and the lens ring is tightly secured before submersing the fixture.
WWSL2
HARDSCAPE LIGHTS - WWHL6 / WWHL12
Installation
Hardscape Lights are designed to be installed into walls and columns, just under capstones.
The diode assembly can be replaced without removing the cord or the capstone.
The round 18" long cord between the driver and the luminaire cannot be cut, and some
accommodation must be made for the driver in most applications. We recommend installing a
1" conduit into the wall to accommodate the cord before installing the fixtures. When installing
the mounting bracket, make sure the stone above the bracket does not rock or pinch the cord.
The holes in the bracket serve as glue points to hold the bracket in place.
NOTE: The Hardscape Lights are not submersible.
Maintenance
Replacement diode assemblies are
available for Hardscape Lights. Remove the
screws on the existing light, being careful
not to let the diode assembly fall, as this
could break the plug connecting the light
to the cord. Lower the diode assembly and
squeeze the locking clip to separate the
plugs. Plug in the new diode assembly,
making sure the gasket has not moved or
shifted and that the notched edge of the
diode assembly fits between the two ridges
on the cord gasket. Align the screw holes and
hand tighten the screws.
4
Diode
WWHL6