Publicité
Les langues disponibles
Les langues disponibles
Lighting Instructions when Using Match
Read and understand all safety information
before operating heater.
WARNING: Do not raise burner
heads and cover air inlet holes in
mixing tube.
WARNING: Make sure there is no
open flame in the area. Fully open the
propane tank valve.
1. Turn heater regulator knob counterclockwise
to the Hi position. (Fig. 3)
Burner Front
Ignltion
Hole
Safety
Shut-off
Valve
Plunger
Heater
Regulator Knob
Fig. 3 Burner front.
WARNING: Stand to the side of unit
while lighting. Do not stand or have any
part of your body over or in front
of heater while lighting.
2. Do not attempt to light one burner off of the
other. Use one match per burner. Locate
ignition hole in side of burner. (Fig. 4) Hold a lit
match under ignition hole.
CAUTION: Do not insert match into
air inlet holes in mixing tube.
3. Push in the safety shut-off valve plunger (Fig. 3)
WARNING: Do not push in safety
shut-off valve plunger before
inserting lit match.
6
All manuals and user guides at all-guides.com
TT15 Series
Ignition Hole
Air Inlet Hole
Safety
Shut-off
Valve
Fig. 4 Place lit match under ignition hole.
4. Burner should light. Mesh screen on burner
glows red when lit. After burner is lit, continue
holding in safety shut-off valve plunger (about
10 - to 30 seconds) until heater stays lit.
5. If the burner does not light within 30 seconds,
turn regulator knob to the OFF position. Wait
at least two minutes for the gas to dissipate
before relighting.
6. If heater will not light after repeated tries, do
not attempt to repair heater. Return heater to
nearest authorized service center or to the
address on back of this manual, freight
prepaid.
7. After burner lights, turn the heater regulator
knob to the desired heat setting (LOW, MED,
or HI)
8. For dual burner models only : Light both
burners when maximum heat is needed. Use
one burner to conserve fuel.
Repeat steps to light second burner.
To Turn Off Heater
1. Tightly close propane tank valve by turning
clockwise.
2. Turn the heater regulator knob to the OFF
position. Wait at least 15 minutes for the
heater to cool before handling heater.
3. Always remove the heater from the propane
tank after each use. Do not store heater while
attached to propane tank in an enclosed area.
VENTILATION
Always be sure to supply proper ventilation
while operating this heater. Provide a
minimum of 1/2 square foot opening for
fresh air supply for 15,000 BTU's of heat
and one square foot opening for
30,000 BTU's of heat.
TT15 Series
Publicité
