Publicité
Les langues disponibles
Les langues disponibles
Heater Assembly
(Dual burner models only)
The tank collar bracket must be assembled before
the heaters can be attached to the propane tank.
1. Align bolt holes in tank collar bracket and piezo
bracket with bolt holes in center plate on
manifold.
2. Drive-in two machine screws (supplied) into the
bolt holes attaching tank collar bracket and
piezo bracket (only in some models) to center
plate on manifold. (Fig. 1)
3. Connect spark plug cable(left) and spark plug
cable(right) into each terminal of piezo lighter
(only models with peizo igniter included).
CAUTION: The spark plug cables have
different connectors. Be sure to connect
each spark plug into the correct terminal.
Make sure terminals are securely
connected (only models with piezo igniter).
Manifold
Spark Plug
Cable(Left)
Center Plate
Piezo Bracket
Tank Collar Bracket
TT30 Series
Fig.1 Assemble tank collar bracket.
Connecting Heater to Propane Tank
Read and understand all safety information
before connecting heater to propane tank.
1. (Applies to dual burner models only). Place
heater onto tank with tank collar bracket over
tank collar (Fig. 1) Mounting bolt knob should
be positioned to the outside of tank collar.
2. (Applies to dual burner models only). Firmly
secure to tank by hand-tightening mounting
bolt knob. Do not overtighten mounting bolt
knob.
3. Make sure heater regulator knob is in the
OFF position.
4. For single burner models: insert regulator's con-
nector into tank's valve outlet fitting and turn left
(counterclock-wise) until fully tightened. For dual
burner models: insert regulator's connector
4
All manuals and user guides at all-guides.com
Fuel
Connector
Nut
Spark Cable
(Right)
Heater
Regulator
Knob
Machine
Screw
Mounting Bolt
Knob
Propane
Tank
Valve
Heater
Regulator
Knob
TT30 Series
Fig. 2 Attach heater to tank with tank collar bracket.
into tank's valve and turn left (counterclock-wise)
with hand as much as possible. Then, with a
wrench, continue turning in same direction until
assembly is fully tightened.Threads are left-handed.
NOTE: The vertical stem of this heater is designed
to tilt and/or turn left and right. This permits easier-
attachment to the LP tank and adds versatility to
operation of the heater. THIS IS NOT A DEFECT.
5. Connect the hose to inlet connector. (Fig. 2)
Tighten firmly using wrench. Make sure hose is
connected before opening the tank valve.
6. Open propane tank valve slowly.
7. Check all fittings for leaks. Apply a 50/50 mixture
of liquid soap and water to all joints. Bubbles
forming show a leak. Correct all leaks at once.
WARNING: Never use an open flame to
check for leaks.
8. Always remove propane tank from heater after each
use. Do not store heater while attached
to propane tank.
Operation
WARNING: Burner and Burner Guard
should always face away from
propane tank shut-off and regulator.
WARNING: Improper installation,
alteration, service or maintenance
can cause property damage, injury or death.
Read the installation,
operating and maintenance
instructions thoroughly before
installing or servicing this
equipment.
Operating information
This is a propane, direct-fired, heater. Its
intended use is primarily temporary heating of
buildings under construction, alteration or repair.
Inlet
Connector
Piezo
Mounting Bolt
Knob
Fuel Connecting Nut
Publicité
