AquaScape PRO AIR 20 Instructions Et Entretien page 4

Instructions
STEP 1
SET COMPRESSOR
• Set the compressor in the
desired location (Ex.1).
Select a location near
a ground fault circuit
interrupter (GFCI) rated
receptacle.
NOTE: Do not submerge
the compressor in water.
We recommend placing it in a location above the pond's
water level, whenever possible, to prevent water from
entering the compressor.
STEP 2
ATTACH TUBING
• Attach tubing with a check valve to the barbed
compressor outlet (Ex. 2). It is recommended to use a
hose clamp to secure the tubing to the outlet.
NOTE: Installing a check valve will prevent water from
siphoning back through the tubing and entering the
compressor. Failure to properly install a check valve may
result in the compressor being permanently damaged,
voiding the warranty.
STEP 3
ATTACH TUBING TO DIFFUSER
• Attach the other end of the tubing to the diffuser (Ex. 3). It
is recommended to use a hose clamp to secure the tubing
to the diffuser.
4
STEP 4
SET DIFFUSER IN POND
• Set the diffuser in the pond (Ex. 4).
Ex. 1
STEP 5
PLUG IN COMPRESSOR
• Plug the compressor
into a ground fault circuit
interrupter (GFCI) rated
receptacle (Ex. 5) and enjoy
the benefits!
Ex. 2
Ex. 3
☎ ☎
US (866) 877-6637 | CAN (866) 766-3426 | aquascapeinc.com
Ex. 4
Ex. 5