Lancom 8011 VPN Guide D'installation page 19

LANCOM Routers, WLAN Routers, Access Points and WLAN Controllers
Supply power
necessary, switch on the power switch.

Searching and configuring devices ...
A LANCOM router, wireless router, access point or WLAN controller can be
configured in the following ways (provided that the model is equipped with
the according interface):

Via the local network (LAN) ³.
Via the wireless network (WLAN) ·, if WLAN encryption (e.g. WEP) has
LANCOM WLAN
routers only
been correctly set up (or deactivated) in the configuration computer and
the device with the wireless interface.
As of LCOS version 7.22 all LANCOM access points are set to "Managed
Mode" when shipped, and the WLAN modules are switched off. For this
reason the first-time configuration of LANCOM access points via WLAN is
not possible.
Via the serial configuration interface ».
3
All manuals and user guides at all-guides.com
in the LANCOM (default = on). Contradictory settings can lead to data
transfer errors, either immediately or after some time (days).
via the provided power supply unit resp. power cable. If
Some devices support power supply via the LAN cable (Power-over-
Ethernet – PoE). Please notice the corresponding advice at the rear of
your device.
If your network is equipped with a LANCOM WLAN Controller, net-
work commissioning of wireless routers and access points is generally
fully automatic. For further information please refer to the user
manual supplied with your LANCOM WLAN controller.
First steps