Landmann AG-VI-103BKXX Mode D'emploi page 16

■ Never look directly into the light source! Never point the cone of light directly at
other people or animals. There is a risk of glare!
■ Disconnect the product from the power source if an error occurs during charging
or before a thunderstorm.
■ In the event of damage / faults, switch the product off immediately. Do not use
it if it is damaged.
■ Do not make any modifications to the product. It may only be taken apart and /
or repaired by the manufacturer, customer service department or a similarly
qualified person (e.g. specialist workshop) in order to avoid any hazards.
■ Caution: The light source contained in this product may only be replaced by the
manufacturer, his service representative or a similarly qualified person.
■ If the battery leaks, do not allow your skin, eyes and mucous membranes to
come into contact with the battery acid. If you do touch battery acid, rinse
the affected areas with clear water straight away and seek medical assistance
immediately.
■ Protect the product from: impacts, sub-zero temperatures and moisture.
■ Use only original accessories from the manufacturer.
CHARGING UP THE BATTERY
■ PLEASE NOTE! Do not charge up the product on a computer because the com-
puter might be damaged by the high charging current.
Charge up the battery fully before you first use the product so that it reaches full
capacity.
If the battery status indicator (10) indicates an empty battery (The display (7) must
be switched on.) or if the light can no longer be switched on, the battery needs to be
charged.
The battery should preferably be charged via a USB mains adapter (5 V and
≥1000 mA; not supplied with the product) connected to a plug socket.
1. Pull out the cap of the USB socket (4).
05194_Inlay_145x110_V2_8spr_0422.indb 11 05194_Inlay_145x110_V2_8spr_0422.indb 11
EN
11
29.03.2022 12:38:59 29.03.2022 12:38:59