Publicité
Les langues disponibles
Les langues disponibles
4 CLEANING AND MAINTENANCE
• All the parts that can be removed from the unit may be washed
in water They are also dishwasher safe
• Never immerse the housing base in water or spray it with water.
Clean it using a damp sponge, cloth or household paper towel
only When doing so, use washing up liquid, never use abrasive
cleaning products which could scratch the surface
• To make cleaning the unit easier, always wash it immediately
after use Vegetables and fruit will harden if you leave them to
dry on the appliance parts, which will make it more difficult to
clean
1 Unplug the juice extractor
2 Remove the parts of the extractor by following the dismantling
instructions (section 3B)
3 First rinse the parts in cold water Then clean the pulp container,
the juice pitcher, the pusher, the lid and the filter in warm,
soapy water or place these parts in the dishwasher Do not use
metal brushes or sponges
CAUTION: Handle the filter with care when washing because the
blades at the base of the basket are very sharp For more juice,
always carefully clean the filter using the brush provided
4 Dry all parts with a towel
All manuals and user guides at all-guides.com
5 FAQ
PROBLEM
The juice extractor does not
turn on
The flow of juice is slow
Herbs or leafy vegetables are
difficult to push down the
feed tube
The ingredients leak from the
feed tube
Some juice is always leaking
from the appliance when it is
turned off
The appliance turns on but
the juice/pulp does not flow
SOLUTION
• The safety bar is not
positioned in the recesses
• Press the I/O switch to start
extracting juice
• Ensure that the flow spout is
fully opened
• Too much pulp in the filter
can slow the flow of juice
Turn off the juice extractor
and clean the filter
• Place these ingredients
between the other
ingredients
• There may be too much pulp
in the pulp container Turn
off the juice extractor and
remove the pulp Replace the
pulp container and start the
juice extractor
• Make sure the flow spout is
closed properly
• Make sure the filter is
properly positioned
13
Publicité
