Hayden MoFo Serie Mode D'emploi page 4

Lil' MoFo 2 Head
Reverb
Where fitted the Reverb control allows the user to vary the amount of reverberation applied to the
signal before being fed to the power amplifier. Reverb is used to add "space " around the sound
and enhances the tone of the amplifier.
Master
The Master Volume controls the final amount of signal that is fed to the power amp and therefore
the overall volume of the amplifier. The Master works in conjunction with the Gain control as fol-
lows. For clean tones the Master needs to be fully up, controlling the overall volume with the Gain
control. For distortion tones at controllable levels, turn the Master down and the Gain up. Varying
the Gain will control the amount of distortion and the Master will control the overall level of the
sound.
Effects loop (where fitted)
The FX sockets on the front or rear panel are 1/4" jack connectors which accommodate both the
signal send to the effects pedal or rack, and the return back from the effects unit to the amplifier.
It is therefore necessary to use either a stereo cable terminated in two mono 1/4" jack plugs at one
end (which connects to the FX sockets on the amplifier) and a pair of mono 1/4" jack plugs at the
other (which connect to the input and output of the effects unit Or alternatively two mono jack to
jack leads.
Studio /Stage (where fitted)
The Studio/Stage switch is located on the front the amplifier. When switched into Studio mode,
the output of both the MoFo and Mini MoFo is reduced to just approx 2 Watts, enabling the full
range of tones to be achieved at low volume levels in recording application.
Hayden Amplifiers reserve the right to change specifications without notice. E & O E. All contents © Hayden 2013.
www.haydenamps.com
Dual MoFo 15 Combo
DUAL MOFO 15W COMBO
Dual Channel Models
The dual channel models feature controls as described above but in varying combinations....
On the Mofo Dual there are two separate preamplifiers each with its own signal path, each has its own set
of controls comprising of GAIN, BASS, MIDDLE ,TREBLE and MASTER volume.
There is also a REVERB control that affects the reverb applied to both channels. A Momentary type foots-
witch( supplied ) is required to change channels.
Rear Panel sockets
On ALL models there is the Mains inlet this is a IEC connector which Must have a Mains lead plugged into i
this must be of an approved type and it MUST be the 3 WIRE GROUNDED type (see safety notes elsewhere i
this manual).
Mains switch is also situated on the rear , this is used to turn the unit on and off between playing sessions,
(disconnect from the mains supply if it is intended not to use the unit for several hours or days ).
Speaker outputs
Speaker outputs are ¼" jack connectors either 8Ohms or 16 Ohms ( note that it is imperative you do not
operate the unit without a speaker plugged in !)
On the lil Mofo Head there is only 1 output jack that will accommodate either an 8 or 16 Ohm load.
Hayden Amplifiers reserve the right to change specifications without notice. E & O E. All contents © Hayden 2013.
www.haydenamps.com