Hartan ZX II Mode D'emploi page 16

All manuals and user guides at all-guides.com
Instructions for use
Transportation lock
In order to be able to use the pram, you need to open the strap buckle 21. For
transport, fold the pram; and remember to close the buckle to prevent it from
unfolding.
Unfolding the pram
By pushing the lock buttons 4, unfold the upper section to bring the handle in
horizontal position. Pull handle 1 upwards until handle catch 2 has engaged.
WARNING! Before using the pram, make sure all catches are locked.
Folding the pram
Turn safety turn-lock 3 inward until the handle's 2 catch has released. Push
handle 1 downwards to fold the pram. By pushing the lock buttons 4, fold the
handle's upper section inward.
WARNING!We recommend proceeding with caution when folding and unfol-
ding the chassis, and adjusting the backrest, as there is a risk that you do your-
self an injury such as jamming your limbs, fingers, etc.
Changing of wheels
Push the button 5 to release the retention, and pull off the wheel.
Push the wheel right to the axle's stop, and press down the button.
Make sure, all wheels are held in place properly.
Lock-type-swivel wheels
Turn down the lock lever 6 to pre-select the straight-line motion mode, which
will be activated as soon as any wheel starts to point in forward direction. The
lever 6 will act on both the right and left wheels as well. To allow the wheels
to swivel freely again, turn the lever 6 back to the
horizontal position until it snaps into place.
ATTENTION!
Remember to clean the wheel blocks on a regular
basis depending on the dirt accumulation degree.
Dirt, sand, muddy water, salty slush, etc. may
cause a deposit accumulating inside the sleeves,
and thus restricting the swivelling movement.
Clean the guiding pin as well as the guiding and
locking sleeve using a damp cloth. If necessary,
rinse them out with clear water, rub them dry, and
spray them using a silicone based lubricant.
Do not use oil! When cleaning the wheel
block, press down the metal clamp to separate
the halves and pull off the lower section.
12
IMPORTANT!
Locking sleeve
Arretierhülse
Guiding sleeve
Führungshülse
A
B
Demontage
Dismounting
Depress metal clamp (A)
A Metallklammer drücken
and pull off wheel block
und B gleichzeitig
(B).
Radblock abziehen.
Guiding pin
Führungszapfen
B
A
Montage
Mounting
Depress metal clamp (A)
A Metallklammer drücken
and slide on wheel block
und B gleichzeitig
(B).
Radblock aufstecken.