Brandson Equipment 305872 Mode D'emploi page 13

4.4 Buttons
The following table provides an overview of the button functions:
SET
ENERGY
COST
UP
RESET
5. Adjusting the energy price
• If the energy cost meter cannot be started, then press the reset
button for a few seconds.
• The internal rechargeable battery will discharge if the timer
switch is not used for longer periods of time. Plug the energy cost
meter into a mains plug for approx. 24 hours every 3 months to
charge the internal rechargeable battery.
• Press and hold the cost button for approx. 3 seconds in order to
enter your current energy price per kilowatt-hour. The display
flashes Cost/KWh.
• Use the set button to select the digit you would like to enter.
• Set the desired value using the Up buttons.
• Press the cost button to save the entered value and leave input
mode.
English
• Changing the information displayed in Energy and Cost
display
• Selecting the digit to be changed when setting the ener-
gy price or overload limit
• Changing the information displayed at the Energy display
• The overload limit can be adjusted by pressing it for 3
seconds
• Changing the information displayed at the Cost display
• The energy price can be adjusted by pressing it for 3
seconds
• Changing the selected digit when setting the energy
price or overload limit
• Resets the power cost monitor if the display is incorrect
or if the meter does not respond to the pressing of
buttons
13