Mr. Blacksmith 9009432 Mode D'emploi page 6

Failure
Battery Pack not properly
connected.
Tool will not
Battery Pack not properly
start.
charged.
Battery Pack not properly
charged.
Internal damage or wear. (Carbon
brushes or Trigger, for example.)
Forcing tool to work too fast.
Tool operates
slowly.
Battery Pack wearing out.
Performance Carbon brushes worn or damaged.
decreases over
time.
Excessive Internal damage or wear. (Carbon
noise or
brushes or bearings, for example.)
rattling.
Forcing tool to work too fast.
Overheating.
Blocked motor housing vents.
All manuals and user guides at all-guidesbox.com
Possible Cause Corrective Action
Remove Battery Pack, make sure
there are no obstructions, clean
battery contacts on tool, reinsert
the Battery Pack according to its
shape (it should only fit one way),
and
press firmly until the Battery Pack
locks in place.
Make sure Charger is
connected and operating
properly. Give enough time
for Battery Pack to recharge
properly.
Dispose of old Battery
Pack properly or
recycle. Replace
Battery Pack.
Have technician service tool.
Allow tool to work at its own rate.
Dispose of old Battery Pack
properly or recycle. Replace
Battery Pack.
Have qualified technician replace
brushes.
Have technician service tool.
Allow tool to work at its own rate.
Wear ANSI-approved safety
goggles and NIOSH-approved
dust mask/respirator while blowing
dust out of motor using
compressed air.