Mr. Blacksmith 9009432 Mode D'emploi page 4

All manuals and user guides at all-guidesbox.com
2. To remove, pull Collar forward, remove bit from Chuck and then release Collar.
Attaching Belt Clip
Attach Belt Clip to Handle using supplied Screw. Clip may be attached to either side.
General Operating Instructions
1.Make sure that the Trigger is in the off-position, then attach the Battery Pack.
2. Insert an appropriate impact-rated accessory (sold separately) into the driver.
3. Set Direction Switch.
Forward: Push Switch in on right side (arrow pointing forward) for clockwise rotation.
Reverse: Push Switch in on left side (arrow pointing backward) for counter-clockwise rotation.
Trigger Lock: Push Switch to the center to lock the Trigger.
CAUTION! Set Direction Switch to center Trigger Lock position during set up,
when changing bits or when tool is idle.