Philips BC8210 Mode D'emploi page 9

XP SBC BC 8210/00-1.1
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or
service centre.
WARNING: Under no circumstances should you try to repair the set yourself, as this
would invalidate the warranty.
Problem
No sound
Distorted sound
20-08-2001 13:43
All manuals and user guides at all-guides.com
Remedy
– Check if the AC/DC adapter is fully inserted into the
AC outlet and that its DC connector is properly inserted
into the 12 Volt DC input connector located at the rear
of the transmitter.
– Check if the speaker's on/off switch is in the on
position.
– Speaker batteries running low.
Connect to the 9 Volt/500 mA AC/DC adapter.
(See Speaker power supply)
– Check if the audio source is switched on and tuned to
a channel with audio.
– Volume not adjusted. Adjust the volume on the audio
source/ speaker to a higher level.
– Adjust the speaker's tuning frequency.Turn the tuning
wheel until the signal is at its clearest.
– Make use of the HC8372 transmitter. Some
transmitters already built into other equipment may not
be compatible with the BC8210 speaker because of the
advanced technologies used in the BC8210 speaker.
– Adjust the speaker's tuning frequency.Turn the tuning
wheel until the signal is at its clearest.
– Adjust the transmitter's frequency.
Select any of the 2 channels of the transmitter.
– Speaker batteries running low.
Connect to the 9 Volt/500 mA AC/DC adapter.
(See Speaker power supply)
– Check the volume on audio source/ speaker is not set
at too high a level. Reduce the volume.
Pagina 9
Troubleshooting
9