Télécharger Imprimer la page

Kathrein EXE 159 Mode D'emploi page 11

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Installation and Safety
The equipment described is designed solely for the installation of satellite
receiver systems.
Any other use or failure to comply with these instructions will void the war-
ranty or guarantee.
The equipment may only be installed in dry areas i
or against highly combustible materials.
The equipment must be provided with an earthing wire (Cu, at
The safety regulations set out in the current EN 60728-11 and EN 60065
standar
Fixings: Screws, max. Ø: 4 mm
Connectors: RF connector 75 Ω (series F) acco
Unused RF ports must be
An inner cable conduc-
tor diameter greater than
1.2 mm, or the presence
of burrs may damage the
sockets on the unit.
Current-carrying device
Do not open the unit or tamper with it!
When working on the system always unplug the power supply unit from the
wall socket!
The device is intended only for wall mounting! Do not install the device lying
fl at or on its top, or operate it in th
Ensure adequate clearance! Clearance all round at lea
Free circulation of air must be possible to discharge the heat emitted by the
ni
u
t. Danger of overheating!
Ambient temperatur
Caution:
No liquid-fi lled items may be placed on top of the power supply unit.
• T
he power supply unit must not be exposed to dripping or splashing w
The mains plug must be easily accessible and operable.
The only reliabl
plug it.
All manuals and user guides at all-guides.com
ds
must be complied with.
te
rminated with 75 Ω resistors (e.g. EMK 03).
e
range -20 to +55°C
e
method of disconnecting the unit from the mains is to un-
3 / 8
nd
oors. Do not install on
rdi
ng to EN 61169-24.
Max. 2 mm
excess
length
Tightening
torque 3.4 Nm
(danger of
overwinding)
is
position.
st
le
ast 4 mm
).
2
Diameter 0.6-1.2
mm free of burrs
5 cm!
at
er.

Publicité

loading

Ce manuel est également adapté pour:

Exe 2592051006320510064