Table des Matières
Publicité
HOW TO USE
To adjust the speed, move the speed control to the required position :
0 : to stop
1 : slow
2 : medium
3 : fast
To make the fan head oscillate, push in the knob on the motor housing. To stop the fan
from oscillation, pull up on the knob.
To adjust vertical angle, tilt fan head up or down as desired.
ASSEMBLY
MONTEER THE ROUND FOOT TO THE TELESCOPIC TUBE:
•
At the bottom side of the tube is a "L" shaped screw. Losen this screw.
•
Place the tube in the foot and attache the tub with the "L" shaped screw.
•
Place the motor unit on the telescopic tube. Remove the large black screw from
the tube and the black screw from the motor unit.
•
Place the motor on the tube, make sure the small groove, fits in the little hole on
the tube. Now use the large black srew of the tube, to fix the motor unit to the
tube. Now use the other black screw, to fully fix the motor unit. This last screw
can also be used to tilt the fan.
ASSEMBLY THE FAN TO THE MOTOR UNIT
Remove the small screw at the bottom (1) from the engine part
•
Take the rear grid (the one with a handle)
•
Place the grid with the two pins behind on the grid at
the two openings (2) on the engine part
•
Carefully move the grid down
•
Secure the grid back onto the engine part by the bot-
tom screw (1)
•
Push in firmly until the pins protrude through the
holes.
•
Secure the rear guard to the motor unit with the rear
guard lock nut.
•
Insert the fan blade onto the motor shaft. Be sure that
the pin in the shaft is match with the slot on the fan
blade. Press firmly until the fan blade stops. Secure the
fan blade with the fan blade screw.
•
Test the fan blade operation by rotating it with your hand. There should be no fric-
tion with the rear guard lock nut. If the blade does not rotate freely, disassemble
and repeat the procedure.
27
2
1
DO8132
2
Publicité
Table des Matières
