Publicité
a/ Comprises removing metal from the part surface,
b/ Clamp the part into the chuck, always use the same jaw tightening square. Never let
the part protrude by more than twice its diameter (spinning in the air),
c/ Position the tool tip so that it is perfectly aligned with the part axis (to do this, use steel
shims that are placed under the tool body)
d/ Start the machine after first setting the speed in rpm.
e/ Angle the tool to the part face, push the tool back, set a cutting depth of 0.5 to 1 mm
max. by turning wheel 17 on the longitudinal carriage, then advance towards the centre
of the part by turning wheel 18 on the transverse carriage at a consistent rate.
f/ Never remove the part if it is to be corrected
g/ Where possible, lubricate using a can containing soluble oil and water and a brush.
WARNING: Always wear protective goggles and remove the chips using a
hook, never with your hands
a/ This comprises removing material over the diameter of the part,
b/ Use a cutting tool, position the tool tip perfectly in line with the part axis,
c/ Start the machine to allow automatic advance after first setting the speed in rpm
114135-Manual-D-EN.indd 16
All manuals and user guides at all-guides.com
VARIOUS GRINDING/MILLING OPERATIONS
FACING
N =
STRAIGHT TURNING
N =
© FAR GROUP EUROPE
1000 x V
π x D
A right hand 45° facing tool
1000 x V
π x D
21/03/12 10:44:56
Publicité
