Lindy 52022 Guide Condensé page 7

English Short Manual
4. Troubleshooting
If you have trouble using the W-LAN 11 Wireless LAN Access Point, the starting point to
troubleshoot any problems is by looking at the LED activity on the Access Point. The following
"LED Error Table" is provided to assist you in diagnosing and solving operational problems.
PWR AP
Continuous
Green
Continuous
Green
On
Off Off
Off
Continuous
Blink Green
Green
Blink Green
Blink Green
If you are still unable to solve the problem by checking the LED activity, the error may be caused by a configuration
mismatch which prevents the W-LAN 11 from establishing a wireless connection with your network. You may check
the following to ensure normal operation of the W-LAN 11.
n
WEP keys: If data encryption is activated, always remember to set WEP keys exactly the same on
the Access Point as are on the wireless stations.
n
Access Control: Make sure that the MAC address of your W-LAN 11 is not included in the Access
Control table of other wireless devices.
All manuals and user guides at all-guides.com
WLAN LAN LINK
Steady
Flash Flash
Green
Green Green
-
Off Off -
Off Off Off
Off Off Off
- - -
Blink
- -
Green
Blink
- -
Green
Description/Action
Normal operation where
flickering indicates interface
n activity.
No action required.
Normal operation that indicates
there is no LAN activity.
n
No action required.
n
Power failure.
n
Check the power cord.
Check the power supply.
Invalid loader firmware or the
n micro-controller is dead.
Return the unit to the vendor
for support.
n
Invalid Access Point firmware.
Upgrade the firmware via
the utility or console mode.
n
Wireless LAN initialisation failure
Check whether the wireless
module has been properly
installed.
n
Ethernet initialization failure
Return the device to the
vendor for support.