Publicité
Les langues disponibles
Les langues disponibles
English Short Manual
Rear view of your W-LAN 11 Access Point:
POWER
Power:
Connect the power adaptor here.
MDI:
RJ-45 connector for Ethernet Hub with10BaseT or 100BaseTX.
MDI-X
RJ-45 connector to connect a computer or workstation, you can only use one of
the MDI / MDI-X marked connectors!
RS-232
Console port to configure and program the Access Point
LED's
status display for the wired Ethernet
After correct installation of all connections to the wired LAN the Link LED should always light
green when the hub or the workstation/computer is switches on.
The top panel of the W-LAN 11 Access Point
The following table provides an overview of each LED activity:
LED Definition
PWR
AP
WLAN
LAN
LINK
3. Configuration / Installation
The Access Point provides a user friendly configuration utility (Access Point Manager). It is
delivered ready for use with factory default settings for use with standard W-LAN conditions.
Any configuration changes may be made using the Access Point Manager software, by web
browser administration or by console set-up using either the RS-232 console administration or
direct Ethernet Telnet connection.
All manuals and user guides at all-guides.com
100M TX
MDI
Link
RX
OR
Activity
Continuous Green
Continuous Green
Flashing Green
Flashing Green
Continuous Green
MDI-X
RS-232
Description
Power enabled
The W-LAN 11 is now in service.
Off: No wireless activity
Flashing: Wireless RX/TX activity
Off: No Ethernet traffic activity
Flashing: Wired LAN traffic
activity
Off: no station connected to the
Access Point
On: with one or more stations
associated to the W-LAN 11
Publicité
