Hubbell PRS Instructions D'installation

WARNING! Fixtures must be grounded and installed in accordance with the National Electrical Code and all local codes.
Failure to do so may increase the RISK OF PERSONAL INJURY, PROPERTY DAMAGE, FIRE AND DEATH. Install and
use so fixture failures do not cause a hazard and use only in environments for which the product is specifically marked.
WARNING! This product contains chemicals known to the State of California to cause cancer, birth defects, and/or other
reproductive harm. Thoroughly wash hands after installing, handling, cleaning, or otherwise touching this product.
CAUTION! Follow ALL luminaire recommendations, product markings, instructions, restrictions and warnings regarding
luminaire operation and burning position. Luminaire label shows electrical and environmental requirements and
restrictions.
All electrical work must be done by a qualified electrician.
Turn off electric power to all affected circuits and allow to cool before servicing.
A regularly scheduled maintenance program should be established to retain optimum light output and reduce heat
retention. Dusting with a soft, clean, dry cloth is normally sufficient for the optical system. Any accumulation of dust or dirt
should be removed regularly.
Carefully read these instructions before installing product. If you do not understand these instructions, before starting any
work, contact your Hubbell Lighting distributor or techsupport@hubbell-ltg.com or (864) 678-1000
Give instructions to facility owner/manager for future reference.
Tools required: Phillips Screwdriver
Wall mount installation only, oriented as shown above in Fig. 1.
Installation steps:
•
(See Fig. 2) Loosen the two lens cover screws and slowly lift cover away. Unsnap the photocell connector that
has wires routing to the inside of the lens cover photocell area. Do not remove the photocell from the lens
cover.
•
(See Fig. 3) Loosen the two reflector screws and remove the reflector.
•
(See Fig. 4) Make sure that the provided gasket is installed on the back of mounting plate. This gasket will
cover the junction box.
•
(See Fig. 5) Slots have been provided for mounting to junction box. (Junction box and junction box screws
provided by others).
•
Make wiring connections and push them back into the junction box.
•
Reinstall the parts removed in the earlier steps.
Hubbell Lighting • 701 Millennium Boulevard • Greenville, SC 29607 • Phone: 864-678-1000
Due to our continued efforts to improve our products, product specifications are subject to change without notice.
© 2016 Hubbell Lighting • All Rights Reserved • For more information visit our website: www.hubbelloutdoor.com
All manuals and user guides at all-guides.com
PRS INSTALLATION INSTRUCTIONS
INSTALLATION
INSTRUCTIONS
PRS
READ THOROUGHLY BEFORE INSTALLATION
SAVE THESE INSTRUCTIONS
Fig. 1
93117036 - Page 1 of 4