Hubbell PRS-20-5K Instructions D'installation

WARNING! Fixtures must be grounded and installed in accordance with the National Electrical Code and all local codes. Failure to do so may increase
the RISK OF PERSONAL INJURY, PROPERTY DAMAGE, FIRE AND DEATH. Install and use so fixture failures do not cause a hazard and use only in
environments for which the product is specifically marked.
WARNING! This product contains chemicals known to the State of California to cause cancer, birth defects, and/or other reproductive harm. Thoroughly
wash hands after installing, handling, cleaning, or otherwise touching this product.
WARNING! Dangerous voltage exist within the unit and all precautions usually observed in handling high voltage equipment should be observed when
replacing light engine or otherwise servicing luminares. Disregarding this warning could result in electrical shock and possible injury to the individual
installing or servicing this equipment. Installation and servicing should be done by qualified personnel.
CAUTION! Follow ALL luminaire recommendations, product markings, instructions, restrictions and warnings regarding luminaire operation and burning
position. Luminaire label shows electrical and environmental requirements and restrictions.
NOTE! This luminare is designed for outdoor lighting applications with ambient temperatures not exceeding 40°C (104°F).
All electrical work must be done by a qualified electrician.
Turn off electric power to all affected circuits and allow to cool before installation or servicing.
A regularly scheduled maintenance program should be established to retain optimum light output and reduce heat retention. Dusting with a soft, clean,
dry cloth is normally sufficient for the optical system. Any accumulation of dust or dirt should be removed regularly.
Carefully read these instructions before installing product. If you do not understand these instructions, before starting any work, contact your Hubbell
Lighting distributor or techsupport@hubbell-ltg.com or (864) 678-1000
Give instructions to facility owner/manager for future reference.
Tools required: Phillips Screwdriver, Drill, and drill bit.
Wall mount installation only, oriented as shown above in Fig. 1.
Installation steps:
•
(See Fig. 2) Loosen the four front cover screws and slowly lift cover away. Grasp the white photocell connector and
unsnap by using a gentle pull. This connector and wires are located inside of the lens cover photocell area (See Fig
3).
•
Also firmly grasp both sides of the orange connector and gently pull to disconnect. Now the front cover assembly can
be placed aside while mounting the backplate shown in Fig 5.
•
(See Fig. 4) Using the provided round gasket, remove the paper backing and stick the gasket to the back of mounting
plate. This gasket will cover the junction box.
•
(See Fig. 5) Only drill the cast pattern that matches your junction box. (Junction box and junction box screws provided
by others).
•
Make wiring connections and push them back into the junction box.
•
Reinstall the parts removed in the earlier steps. Important note: If you do not want the photocell to turn the light on
and off based on the outside light level, all you need to do is not reconnect the white connector(see Fig 3).
Hubbell Lighting • 701 Millennium Boulevard • Greenville, SC 29607 • Phone: 864-678-1000
Due to our continued efforts to improve our products, product specifications are subject to change without notice.
© 2021 Hubbell Lighting • All Rights Reserved • For more information visit our website: www.hubbelloutdoor.com
PRS PERIMASHIELD INSTALLATION INSTRUCTIONS
SAVE THESE INSTRUCTIONS
READ THOROUGHLY BEFORE INSTALLATION
Fig. 1
93117036_B - Page 1 of 4