Publicité
Les langues disponibles
Les langues disponibles
Duct Collar
Figure 4
2. Connect the ducting to the duct collar and secure in place
using tape to seal all joints (Figure 4).
NOTE: The duct connector is 5.8" in diameter (for 6" round ducting)
and the center is located 3-3/16" inches from the back wall.
CAUTION:
ALWAYS DUCT THE FAN TO THE OUTSIDE
THROUGH A WALL OR ROOF CAP.
SECTION 4
Wiring
CAUTION:
ALL ELECTRICAL CONNECTIONS MUST BE MADE
IN ACCORDANCE WITH LOCAL CODES, ORDINANCES, OR
NATIONAL ELECTRICAL CODE. IF YOU ARE UNFAMILIAR WITH
METHODS OF INSTALLING ELECTRICAL WIRING, SECURE THE
SERVICES OF A QUALIFIED ELECTRICIAN.
1. Attach wire compartment to the hood with two of the provided
3.9 x 13 mm screws. Remove wire compartment cover and
connect the Brown wire (on some models this wire will be
white) from the range hood to the White wire from the supply,
and the Blue wire (on some models this wire will be black)
from the range hood to the Black wire of the supply. Connect
the ground wires from the home (green or bare) and the hood
(green/yellow) to the grounding screw in the wire compartment.
Use approved methods for all connections (Figure 5).
Wire
Compartment
Figure 5
60804020 Rev A. 4-05
All manuals and user guides at all-guides.com
Ducting
Hood
Supply from home
White
Hot (Black)
Ground
Brown
Hot (Blue)
From Hood
www.airkinglimited.com
3. Replace the wire compartment cover and tighten screws. Make
sure all wiring is securely contained within the wire compartment.
SECTION 5
Attaching the Chimney
1. Mark the location for the vertical chimney bracket and drill
holes into wall using a 1/4" drill bit. Install included wall
anchors into holes and secure bracket into place with two
provided 3.19 x 32 mm screws (Figure 6).
Side View
Figure 6
2. Press in the two tabs at the base of the bottom chimney
section (section with vent holes) so that there is approximately
1/4" of clearance.
NOTE: If the optional top chimney section (included) will be installed,
slide the top section inside of the bottom section at this point.
3. Slide the chimney in place so the mounting bar is secured in
place behind the vertical chimney bracket and the backside
of the chimney fits between the hood and the wall with the
tabs overlapping the back lip of the hood (Figure 7).
Figure 7
Vertical Chimney
Bracket
1-31/32"
13-3/8"
Details of duct collar, ducting, and electrical have
been omitted from drawing for clarity purposes.
Details of duct collar, ducting, and electrical have
been omitted from drawing for clarity purposes.
3 of 20
Publicité
