MPMan GL50 Mode D'emploi page 8

POWER SOURCES
1. Rechargeable battery pack (included).
2. 3 AA batteries (not included).
3. AC adapter/charger (not included).
4. Continually turning the crank, even with no batteries installed.
CHARGING THE BATTERY PACK
1. Switch the DYNAMO-ADAPTER/BATTERY/OFF switch to the OFF
position.
2. Turn the dynamo-crank clockwise or counter-clockwise about
2 turns per second for 90 seconds.
3. After charging, select the DYNAMO/ADAPTOR position for power.
While charging, the red L ED charging light illuminates.
AA BATTERY OPERATION
1. Open the battery compartment.
2. Install 3 AA batteries, observing polarity diagram.
3. For power, set the power selector switch to the BATTERY position.
USING AN AC ADAPTER (NOT INCLUDED)
Once plugged in, the AC adapter acts as a charger, charging the internal
Ni-MH battery pack. Charge it for 8 hours to achieve a full charge.
1. Plug the adapter into the DC 5V socket.
2. For power, set the BATTERY/DYNAMO-ADAPTER/OFF switch to the
DYNAMO-ADAPTER position.
EMERGENCY OPERATION WITH NO POWER SOURCE
1. Set power selector switch to DYNAMO/ADAPTOR.
2. While continually turning the dynamo crank, radio stations can be tuned
and the lights and siren function.
CELL PHONE CRANK CHARGING
Because cell phone batteries vary in their current ratings, we cannot
specify charging rates or usage time. 10 to 15 minutes of cranking may
result in 1 or more minutes of talk-time.
1. Set power selector switch to OFF position.
2. Plug the cell phone charging cord (not included) into the Phone Charge
socket.
3. Select the correct charging tip (not included) for your phone.
4. Plug charging tip into the charging cord and into the phone's charging
socket.
5. Rotate the dynamo crank.
6
All manuals and user guides at all-guides.com
GL50 English Manual
www.mpmaneurope.com