Trust SMART Home AWMR-230 Manuel D'installation page 13

10. Assign Trust SmartHome transmitter code
While the learn-mode is active, send an ON-signal with any Trust SmartHome transmitter to assign the
code to the receiver's memory.
11. Code confirmation
The receiver will switch on/off 2 times to confirm the code has been received. The receiver can store
up to 6 different transmission codes in its memory. The memory will be preserved when the receiver
is moved to another location or in case of power failure.
12. Mount the receiver in the box
Mount the receiver in the wall or ceiling box and put the original wall switch or ceiling lighting
back in place.
13. Manual operation with a Trust SmartHome transmitter
1. Press ON to switch the receiver on.
2. Press OFF to switch the receiver off.
14. Single code delete
1. Press the learn-button for 1 second. The learn-mode will be active for 15 seconds and the LED-
indicator will blink slowly.
2. While the learn-mode is active, send an OFF-signal of a specific Trust SmartHome transmitter to
delete that code.
3. The receiver will switch on/off 2 times to confirm code deletion.
15. Full memory delete
1. Press and hold the learn-button on the receiver (aprox. 7 sec.) untill the LED-indicator starts
blinking fast. The delete mode will be active for 15 seconds.
2. While the delete mode is active, press the learn button on the receiver again for 1 second.
3. The receiver will switch on/off 2 times to confirm memory deletion.
71035_AWMR-230_ML_MANUAL.indd 2
All manuals and user guides at all-guides.com
AWMR-230 MINI BUILD-IN SWITCH
EN
2
15-4-2016 11:55:57