Optex 750830 Manuel D'utilisation page 20

All manuals and user guides at all-guides.com
F. Connecting to the VCR
This setup enables you to record transmitted audio and video on your remote VCR and also enjoy
the picture and sound on a remote TV at the same time.
1. Connect one set of audio/video (A/V) cables to the A/V output jacks of the receiver (X300A or
X301A) and to the A/V input jacks on your VCR. Be sure the yellow, red and white plugs match
the yellow, red and white jacks on both the system receiver and the VCR. If the VCR has only a
single jack for audio input, connect the white plug to it.
2. If your TV has A/V input jacks, connect another set of A/V cables to the TV's A/V input jacks
and to the A/V output jacks on your VCR.
3. If your TV does not have any A/V input jack, in this case, please connect a 75 ohm coaxial cable
from the TV's antenna in (or VHF/UHF in) to VCR's modulator output.
4. Plug one end of the power adapter into the back of the receiver and the other end into any 230
volt (or 120 volt) wall outlet. Use only the adapter provided.
Note : make sure the ON/OFF switch is in the «OFF» position before connection.
5. Locate and orient the receiver to best video and sound quality.
To power outlet
Receiver
RAC to scart cable
VCR
TV ANT IN
75Ω coaxial cable
TV
Scart cable
Notice d'utilisation du transmetteur Audio/Vidéo 2,4GHz Page 20