Huepar LR-5RG Manuel D'utilisation page 9

Operation
Note: Please turn on the
with the receiver. The receiver can ONLY be used in Pulse Mode.
Power ON/OFF
Power ON: Press
•
Note: When powered on, all the icons will be displayed on the LCD
screen to ensure the LCD is functioning properly.
Power OFF: Press
•
Note: When no laser beam reaches the laser reception window (5) for
battery.
Illuminate LCD
When powered ON, press
•
Accuracy
• When powered ON, the accuracy setting FINE is set, press
switch accuracy setting between FINE and
FINE adjustment
MEDIUM adjustment
Note:
MEDIUM accuracy setting should be selected only when a stable laser
•
beam cannot be obtained due to slight vibrations at or near the work site.
If the point to be measured is at a long distance, the MEDIUM accuracy
•
setting is necessary because heat waves or slight vibrations may
interfere with obtaining a stable laser beam.
Speaker Volume
• When powered ON, the default volume setting is LOUD, to change the
to turn the receiver ON.
again to turn the receiver OFF
to turn ON / OFF LCD illumination.
-7-
of the laser level when using
.
.
.
to