Huepar LR-5RG Manuel D'utilisation page 8

Set Up
The laser receiver can be used directly by hand or be mounted to a
measuring rod, pole, or similar object with the clamp.
Attach the receiver to the clamp by matching with the alignment hole
•
(11) and tighten the tightening knob (16).
•
pole, or similar object.
Tighten the adjusting knob (17) to secure the clamp.
•
Switch on the pulse mode of the laser level.
•
When locating the laser beam, loosen the clamp to allow for up / down
•
positioning.
When the laser beam is found, tighten the adjusting knob (17) again to
•
secure the object.
-6-