Team kalorik TKG BL 1002 Mode D'emploi page 8

Fax +32 2 359 95 50

Always close the jug with the lid before starting to mix. When mixing hot liquid, you have to

be very careful in order to avoid splashing of hot liquid, otherwise you can get burned. Do
not forget to close the feeding hole of the pouring jug with the cap.
Always close and hold the lid of the receptacle before starting to blend. In case the lid

would come up during the mixing of hot preparations in particular (see "caution" on page
8-9), stop your appliance and take the lid off in order to release built-up pressure. Then
restart the operation, holding the lid firm.
The appliance is designed for the preparation of small quantities of food, which have to

be consumed rather quickly. It is not designed for the preparation of large quantities at
once.
Do not touch the blades while the appliance is operating and do not try to block their

movement in any way.
Do not use the appliance without any food in it.

Your appliance must never be switched on through an external timer or any kind of

separate remote control system.
Competent qualified electrician: after-sales department of the producer or importer or any
(*)
person who is qualified, approved and competent to perform this kind of repairs in order to
avoid all danger. In case of need you should return the appliance to this electrician.
IMPORTANT INFORMATION
This appliance is not for professional use. You should follow the requested breaks. Failure to
follow this instruction carefully may result in damage to the motor. Please refer to the rating
label for the maximum continuous usage time (KB xx min where xx is the maximum usage time).
The breaks should last at least 10 minutes.
BE CAREFUL!
Your appliance is fitted with a security device on the pouring jug allowing the functioning of
the appliance only when the jug and its lid are correctly placed on the motor base. If those
conditions are met and the appliance does not start, call your after sales service.
MOUNTING OF THE BLENDER AND USE
 Put the pouring jug on the motor block and turn it clockwise until it locks in place.
 Remove the lid of the blender.
 Fill the pouring jug with the chosen ingredients.
 Close the lid.
 Plug in the appliance.
 Choose the mixing speed with the button on the motor base. Position 0 corresponds to
stopping the appliance, position 1 to a slow speed and position 2 to a fast speed.
 Position "P" (Pulse) is particular because the button has to be kept manually. This position is
generally used to crush ice in order to avoid damages on the blades, but it can also be
used to complete the mixing.
 It is also possible to add liquids or other ingredients anytime without stopping the
appliance. You only have to remove the cap which closes the feeding opening by turning
it and raising it straight up.
 Once you have finished the preparation, stop the appliance (position 0) and unplug the
appliance.
 Remove the jug from the base. Then remove the lid and pour the liquid in the desired
receptacle.
 Caution: your appliance is not designed to mix hot preparations and the glass bowl could
break otherwise. If nevertheless you wish to prepare hot drinks or soups, let the whole cool
down to a temperature lower than about 60°C (tepid preparation) before pouring it into
All manuals and user guides at all-guides.com
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
8
Assembly page 8/32
TKG BL 1002 - 140620