Publicité
Les langues disponibles
Les langues disponibles
5
.5
STEP 5
Close the inflator cover
with the zipper.
5.2. CORRECT ATTACHMENT & SETTING
Put the backpack on and adjust shoulder straps to fit your body. Always fasten hipbelt, chest and leg loop and fit them according to your
body. The ALPRIDE AIRBAG SYSTEM will only be of use to you if the backpack stays on your body during an emergency! Most of the
weight of the pack should be resting on your hips rather than being carried by your shoulders.
5
.9
1
CHESTBELT BUCKLE
STEP 1
2
HIPBELT BUCKLE
STEP 1
G3 shall not be liable for any damages and losses due to incorrect set up, incorrect fitting or incorrect adjustments.
6. INSTRUCTIONS
6.1. REGULAR CHECKS
Your ALPRIDE avalanche backpack requires no maintenance but the following points have to be observed :
1- Deploy the airbag before the new season starts or at least once a year or after the backpack has been exposed to moisture/wet
weather. Check its condition, allow it to dry and fold it back together again.
2- Pack the airbag away only when it is completely dry.
3- Prior to every tour, check all the points described in this user manual and inspect the condition of the system's safety straps and fasten-
ings.
4- Make sure that the cartridges are not pierced (empty) and that the red dot on the inflator systems is not visible on the inflator cover
window.
ENGLISH -6
All manuals and user guides at all-guides.com
5
.8
STEP 6
STEP 7
Pack your backpack for
Put the backpack on and
your ride.
adjust shoulder straps,
chest belt and leg loop to
fit your body.
CHESTBELT BUCKLE
1
2
5
.7
1
2
STEP 8
Open the zipper sleeve on
the shoulder strap and take
out the trigger handle when
you are on the slope.
5
.8
HIPBELT BUCKLE
STEP 2
STEP 2
STEP 9
Before your go on your ride
test the specific hand move-
ment to reach the trigger
handle without deploying!
1
2
STEP 3
STEP 3
Publicité
