Publicité
Les langues disponibles
Les langues disponibles
UNIT
Main
Remote
CHANGE SETTINGS
1. Press and hold MODE for 2 seconds to enter setting
mode.
2. Press
or
3. Press MODE to confirm.
TABLE STAND OR WALL MOUNT
The table stand is in the back of the product. See below
for how to assemble the table stand.
CHANGE SETTINGS
2
3
P/N: 086L003873-076 REV1
6/47
All manuals and user guides at all-guides.com
LOCATION
Indoor Temperature Area
Outdoor Temperature Area
to change settings.
1
To mount the product on a wall, put the stand inside
the back of the unit and then place it on a wall, as shown
below.
1
REMOTE SENSORS
This product is shipped with 2 sensors: THR268 and
THN122N Thermometer Sensors that collect
temperature data. Data can be collected from up to 3
sensors. Additional sensors sold separately.
SET UP SENSOR - THR268
1. Assign a different channel to each remote sensor
by changing the channel switch in the battery
4
compartment of the remote sensor.
2. Select the units of measurement for the temperature
display on the °C/ °F slide switch.
3. Install the batteries strictly according to the polarities
shown.
5
4
3
2
Publicité
