FAR POWER Mode D'emploi page 24

ENGLISH
How to install wall mount
• Choose location near power outlet.
Locate point high enough on wall to allow
wand and motorized floor nozzle to hang
freely.
• Place mount against wall and use pencil to
mark drill holes.
• Drill holes (with 1/4" bit) and insert drywall
anchors. Insert screws through holes on mount
and tighten until firmly attached (Fig. 4).
Drywall anchors
4.
Cord clip
Tool
storage
GB-14
All manuals and user guides at all-guides.com
Cord clip
Tool
storage
How to charge battery and store accessories
(Fig. 5)
• Place assembled vacuum cleaner on wall
mount.
• Plug charger into power outlet and then into
charger port on hand vac.
• Loop charger cord into clips on sides of wall
mount.
• Snap tool(s) into tool storage areas.
Battery indicator lights show level of charge
(Fig. 5)
• Indicator lights stop blinking when fully
charged.
• Charge battery fully before using for the first
time. This may take up to four hours.
5.
Battery
indicator
lights
ENGLISH
GB-15