Brewing Coffee - ninja Kitchen Coffee Bar CF097C Série Guide Du Propriétaire

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

CAUTION: HOT WATER. Do not remove the brew basket or vessel while brewing.
CAUTION: STEAM. Do not touch steam vents or the top of the brewer while brewing.
CAUTION: The brew basket is hot after brewing. Always allow the brewer to cool down before cleaning.
Fig. 16
DRIP STOP
NOTE: If the Drip Stop is closed before you begin a
brew, the brewer will notify you with 5 beeps and the
Drip Stop indicator will illuminate. Set the Drip Stop
to the open position and select your brew type.
CAN'T WAIT FOR THAT FIRST CUP TO BE READY?
When brewing a carafe, close the Drip Stop to pause the
brew cycle and pour a cup. Promptly replace the carafe and
open the Drip Stop to complete the brew. (Fig. 16)
NOTE: If you forget to open the Drip Stop, the Ninja Coffee
Bar
System will pause the brew, and after 20 seconds it
will give you a friendly audible reminder. After 6 minutes, the
brew will be canceled.
CAN'T WAIT FOR THE LAST FEW DROPS?
When the brew cycle is complete, set the Drip Stop to the
closed position to stop dripping from the brew basket.
NOTE: While the Drip Stop is closed, the Drip Stop indicator
will light up in the bottom right hand corner of the control
panel.
NOTE: Remember to open the Drip Stop when you are ready
to brew again. If you forget, your Ninja Coffee Bar System
will give you a friendly audible reminder.

BREWING COFFEE

NOTE: Each brew has a pre-infusion cycle with
varying times. The brew will begin, stop, and be
quiet for a short period of time before it begins
again. This process is used to evenly saturate the
coffee grounds.
NOTE: For hotter coffee, rinse the coffee cup, mug, or
thermal carafe with hot water prior to brewing.
CAUTION: Ensure the coffee cup, mug, or thermal
carafe is completely empty before starting a brewing
cycle. Starting a brewing cycle with coffee in the
vessel could cause an overflow.
CLASSIC
RICH
CLASSIQUE
RICHE
OVER ICE / SUR GLACE
118 ml
4 oz
236 ml
8 oz
Fig. 17
CUSTOM BREWS:
CLASSIC & RICH
Classic Brew - For a smooth, balanced flavor.
Rich Brew - For a coffee that is richer than Classic
Brew and still smooth, with more room for milk and
cream.
1
After filling the water reservoir and adding ground
coffee to the filter, be sure the Drip Stop is open and
the reservoir, basket, and filter are securely in place.
2
Use the Multi-Serve dial to select the size of coffee you
would like to brew. Place the empty vessel you would
like to brew into underneath the brew basket.
NOTE: If making a single cup, lower the Multi-Serve
Cup Platform down and center the cup or mug on the
cup platform. Please ensure you are using at least a
350 ml cup for the Cup size, 415 ml cup for the XL Cup
size, 475 ml travel mug for the Travel Mug size, and
590 ml travel mug for the XL Multi-Serve size.
3
Press the Classic Brew or Rich Brew button and the
brew will begin. (Fig. 17, Fig. 18) Press the Classic
Brew or Rich Brew button again to cancel the brew.
NOTE: The brew will begin, stop, and be quiet for
a short period of time before it begins again. This
process is used to evenly saturate the coffee
grounds.
NOTE: Do not remove water reservoir, brew basket, or
vessel while brewing.
4
The Ninja Coffee Bar System will beep to signal a
completed brew.
NOTE: Rich Brew will use slightly less water and yield
slightly less brewed coffee than Classic Brew.
CLASSIC
RICH
RICHE
CLASSIQUE
OVER ICE / SUR GLACE
118 ml
4 oz
236 ml
8 oz
Fig. 18
ninjakitchen.com
18

Publicité

Table des Matières
loading

Table des Matières