Texas LC 165 Manuel De L'utilisateur page 13

7. Idle speed
1. Let the engine run 5 minutes, so the engine is hot.
2. Set the throttle in the lowest possible position
3. Modify idle speed on the adjustment screw see fig. 6
8. Spark plug

Remove the sparking plug cover.

Brush off dirt from the sparking plug.

Use a sparking-plug wrench to loosen the sparking plug.

Inspect if the isolation is intact.

Clean the sparking plug with a steel brush.

Measure the electrode distance; make sure not to damage the electrode.

The distance should be: 0,7 – 0,8 mm

If the sparking plug is okay, put it back in its place.

Put the sparking plug cover back in its place.
9. Transport and storage
Transport

To avoid any spillage of fuel and oil is it important that the engine is placed horizontal during
transport.
Storage

Let the engine run till it stops.

Loosen the drain screw on the carburettor and drain the remaining fuel.

Reinstall the drain screw, and mount the fuel tube.

Keep the old fuel in an approved container.

Remove the sparkplug and poor 1 tablespoon of oil into the cylinder, mount the sparkplug.

Do not mount the sparkplug cap. Pull the sparking cord, until there is resistance. This will close the
valves and protect them from rust.

Protect the oil with a thin layer of oil to avoid rust.
All manuals and user guides at all-guides.com
IDLE SPEED ADJUSTMENT
Standard idle speed: 1600 ± 150r/min
PROCEDURE
Note: The engine must be cold
TRANSPORT AND STORAGE
13