Working With The Machine - Festool UG-KAPEX KS120 Notice D'emploi

UG-KAPEX KS 120
GB
the base frame may shift the centre of gravity of
the frame upwards and cause it to tip over.
– Before transporting and starting work, make
sure that all screws and connecting elements
are tightened securely. The retaining rails on the
power tool must always be locked firmly in posi-
tion. Loose connections can cause instability and
result in inaccurate cutting.
– Only install and remove the power tool in trans-
port position (see description in the operating
instructions accompanying your compound mi-
tre saw). Otherwise the centre of gravity of the
power tool may prevent you from holding the ma-
chine safely.
– Make sure that long and heavy workpieces do
not disrupt the equilibrium of the base frame.
Always support the free end of all long, heavy
workpieces.
– Do not lift or transport using a crane hook or lift-
ing gear!
6 Assembly
6.1 Base frame UG-KAPEX KS 120
Assemble the two-part base frame [1A].

Move the compound mitre saw to transport po-

sition [2] (see description in the operating in-
structions accompanying your compound mitre
saw).
Attach the retaining rails [3].

Attach the folding/fixed stirrup to the compound

mitre saw with retaining rails and secure [4 +5].
Place the compound mitre saw with retaining

rails on the base frame and secure [6 +7].
Insert the folding/fixed stirrup in the base frame

[8].
6.2 Trimming attachment KA-UG-KS120
 Illustrations for the left trimming attachment -
the right trimming attachment is fitted in the
same way.
Fold down the support foot [9].

Place the trimming attachment in the groove,

secure the lugs [10].
7 Settings
Adjust the following settings before using for the
first time:
Loosen the lugs and hexagon screws on the

trimming attachment [11].
Adjust the attachment horizontally [12].

Align to the correct position [1-13].

Adjust the scale [14].

10
Secure the lugs and hexagon screws [15].

8

Working with the machine

Observe the following instructions:
– Do not overload the base frame. Observe the
maximum load capacity.
– Make sure that the all bayonet fittings are closed
before starting work.
– Always clamp the workpiece securely, especially
long, heavy sections. After the machine has cut
all the way through the workpiece, the centre of
gravity may shift suddenly and cause the base
frame to tip over.
Open the telescopic extension [16].

 If the base frame is to be stored for a relatively
long period: Put away UG-KAPEX KS 120 with
KS 120 as shown in figure [21].
9 Transport
Move the compound mitre saw to transport po-

sition [2] (see description in the operating in-
structions accompanying your compound mitre
saw).
Detach the folding/fixed stirrup and fold in the

saw [17].
Lock in position [18].

 If you purchase both trimming attachments in a
set, you can stow these in the transport pouch
[19] on the base frame [20].
 The base frame can be transported in a vertical
[20] or horizontal [21] position.
10 Environment
Do not dispose of the device as domestic waste!
Dispose of machines, accessories and packaging at
an environmentally responsible recycling centre.
Observe the respective national regulations.
Information on REACh: www.festool.com/reach
Customer service and repair only
through manufacturer or service
workshops: Please find the nearest
address at: www.festool.com/service
Only use original Festool spare parts!
EKAT
4
Order No. at: www.festool.com/service
5
3
2
1
The order numbers of the accessories
and tools can be found in the Festool
catalogue or on the Internet under "www.fes-
tool.com".