MSI Z590-S01 Manuel D'instructions page 19

JCI1: Chassis Intrusion Connector
This connector allows you to connect the chassis intrusion switch cable.
Normal
(default)
Using chassis intrusion detector
1. Connect the JCI1 connector to the chassis intrusion switch/ sensor on the
chassis.
2. Close the chassis cover.
3. Go to BIOS > Security > Chassis Intrusion Configuration.
4. Set Chassis Intrusion to Enabled.
5. Press F10 to save and exit and then press the Enter key to select Yes.
6. Once the chassis cover is opened again, a warning message will be displayed on
screen when the computer is turned on.
Resetting the chassis intrusion warning
1. Go to BIOS > Security > Chassis Intrusion Configuration.
Set Chassis Intrusion to Reset.
2.
3. Press F10 to save and exit and then press the Enter key to select Yes.
JTBT1: Thunderbolt Add-on Card Connector
This connector allows you to connect the add-on Thunderbolt I/O card.
2 16
15
1
All manuals and user guides at all-guidesbox.com
1 TBT_FORCE_PWR
TBT_CIO_PLUG_
3
EVENT#
5 SLP_S3#_TBT
7 SLP_S5#_TBT
9 Ground
11 DG_PEWAKE#
13 TBT_RTD3_PWR_EN
15 TBT_CARD_DET_R#
Trigger the chassis
intrusion event
2 TBT_S0IX_ENTRY_REQ
4 TBT_S0IX_ENTRY_ACK
TBT_PSON_
6
OVERRIDE_N
8
10 SMBCLK_VSB
12 SMBDATA_VSB
14
16 PD_IRQ#
Overview of Components
No Pin
Ground
19