Publicité
STEP 21
Place the cord of the charger through the hole and set the charger into the hole.
Run the cord of the charger through the two wire saddles (10) and then through the
hole in the back panel.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
14
"Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate this device"
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate radio
(x1)
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in
#A70250
a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
ameriwoodhome.com
All manuals and user guides at all-guides.com
14
Run the cord through
the wire saddles (10).
27
10
You
Tube
Publicité
