Direction 2 RZRPROWS1000 Instructions D'installation page 2

Over-tightening any and/or all screws will cause cracks around mounting holes which is not covered by any
b) Partially remove the protective film on both sides and attach pivot components (Item E & F) to the windshield using supplied
hardware (Item D) as shown. All screws that are passing through the windshield will be tightened later in step d). Do not over-
tighten the screws that combine the slide arm with the lower pivot, those 2 parts need to swivel.
c) Attach clamps (Item C) to the roll cage of your vehicle using supplied hardware (Item D) as shown. The clamp sets must be installed
with the threaded inserts aligned from right to left of the roll cage. Tighten only the 4 socket cap screws M6 x 45. Do not tighten the
clamps to the roll cage at this stage; you will need to make adjustments later on.
RZRPROWS1000 - Instructions POLARIS RZR PRO XP Full Tilt Windshield - rev00
IMPORTANT NOTICES
Do not over-tighten the screws
that combine the slide arms with
the lower pivots, those parts
need to swivel.
Threaded inserts
aligned from right to
left of the roll cage
warranty.
Domed
shoulder
washer M6
Internal lock
washer M6
Button head
screw M6 x 18
Domed shoulder
washer M6
Internal lock
washer M6
Button
head screw
M6 x 45
Top pivot
cylinder
adaptor
Locknut
M6
Upper pivot
Slide
arm
Locknut
M6
Button head
screw M6 x 18
Locknut M6
Female
clamp parts
www.direction2.com
Button
head screw
M6 x 18
Lower
pivot
Male
clamp
parts
Socket cap
screws
M6 x 20
2