Lacor 69325 Conseils D'utilisation Et D'entretien page 65

13.- Pressing "Stop" during the cooking process puts the microwave into pause mode. Press
"Start" to continue with the process or "Stop" to cancel and return to the prepared mode.
SERVICE MODE
To verify the quantity of times that the door of the microwave has been opened and closed:
1- Open the door and press "3" for 5 seconds.
2- The display will show "SErU"
3- Press "3" and the display will show the amount of times that the door has been opened and
closed.
4- Press "Start" and press "4" for 4 seconds. The display message will disappear and "4-CL" will
appear.
5- Press "Stop" to return to the prepared mode.
FACTORY PRESET VALUES
Press "Start" and "0" in the prepared mode (the display will show "1:1") to reset the Factory Preset
Values.
CLEANING
1- Always turn off and unplug the machine before cleaning, and make sure to turn the slice
thickness regulator to zero position to avoid cutting yourself.
2- Never use any chemical or abrasive products. Do not use a brush or any other type of utensils
which could damage the different parts and surface of the slicer.
3- Use a damp cloth with detergent to clean the machine and then dry it. Make sure to clean the
machine completely every day.
7- ATTENTION: Do not put the machine directly into any container with water in it. This machine
is not waterproof.
5- If the apparatus is not maintained in a good state of cleanliness, its surface could be degraded
and affect the lifespan of the apparatus and lead to a dangerous situation.
6- For easy cleaning of the cavity walls, half lemon put in a container, add 300 ml. water and set
heat on high for 10 minutes. Then, wipe the microwave with a soft and dry cloth.
65