Publicité
Les langues disponibles
Les langues disponibles
To operate, connect to a properly polarized outlet only. Ensure the unit is in the OFF position. Match wide blade of
plug to wide slot and fully insert. Be sure to plug into a 120V AC, 60Hz outlet. Note: When the heater is plugged
in, the power indicator will be illuminated until it is turned off and unplugged.
NOTE: THE HEATER WILL NOT OPERATE UNTIL THE POWER THE UNIT IS PROPERLY PLUGGED INTO A
POLARIZED OUTLET AND POWERED ON (SEE SECTION ON POLARIZED PLUGS UNDER IMPORTANT
SAFEGUARDS).
YOUR HEATER IS EQUIPPED WITH A POWER SWITCH AND THERMOSTAT CONTROL.
FIG.2: CONTROL PANEL
SAFETY FEATURES OF THIS HEATER
Thermal Cut-Off: The heater will automatically shut off when parts of it overheat. If this occurs, turn the heater
OFF and unplug it. Inspect the unit, and remove any objects that are on or adjacent to the unit that may cause
overheating. Wait 15-20 minutes for the unit to cool down. Then plug it back into the outlet in order to resume
normal operation.
Model Number
Power Supply
Power Consumption
H2NLTGMG2ASF
Bellagio By Airworks
OPERATING INSTRUCTIONS
1. Turn the unit ON by pressing the Power Switch to the [ | ] position.
2. For faster heat up or to increase the heat output, turn the Thermostat Control knob all
the way to the right [+]. The thermostat function controls the temperature output. To
decrease the heat output, turn the knob counter clockwise.
3. Once the room reaches the desired temperature, slowly turn the Thermostat Control
knob counter clockwise until you hear a "click". This sets the heater to cycle ON/OFF
to maintain the desired heating temperature for energy efficiency.
4. To completely shut unit OFF, press the Power Switch to the [
Note: It will normally require approximately 15 minutes to reach operating
temperature.
SPECIFICATIONS
H2NLTGMG2ASF
120 volts AC, 60Hz
700W
O ]
position.
Publicité
