Publicité
Les langues disponibles
Les langues disponibles
PARTS OF THE HEATER
1. Oil fins (x7)
2. Carry handle
3. Power switch
4. Thermostat control
5. Power light
6. Front panel
7. Front leg
8. Hind leg
DO NOT OPERATE THIS HEATER UNTIL FRONT AND HIND LEGS ARE ATTACHED.
(SEE FIG.1)
Assembly Instructions:
1. Unpack the heater and remove all parts from the packaging.
2. For ease of assembly, turn the heater upside down on a soft
surface which will not scratch the unit. Use one hand to hold it
in place.
3. Find the front leg and insert it horizontally into the bottom of
the front panel. Click into place.
4. Find the hind leg and insert it vertically along the last oil fin.
Push the leg into the fin to secure firmly.
Location of the Heater:
1. Turn the heater upright. Ensure legs are correctly installed
and level.
2. Place heater on a flat and stable surface. Setting the heater
on an incline or decline may cause damage to the unit and create a hazardous situation.
3.
Proceed to OPERATING INSTRUCTIONS
CAUTION:
Operate the heater in upright position only. Any other position could create a hazardous situation.
:
CAUTION
Ensure that the surface beneath the heater is clean and free of any obstructions. It is not recommended
that this heater be placed on high pile carpeting or any other surface that impedes the flow of air
underneath the heater.
H2NLTGMG2ASF
Bellagio By Airworks
PARTS OF THE HEATER
ASSEMBLY
.
FIG. 1
Publicité
