Klarstein Steam Buddy Mode D'emploi page 19

All manuals and user guides at all-guides.com
TROUBLESHOOTING
Failure Possible Reasons
Not enough heat Rotate thermostat dial
or Too heat button improperly.
No steam produces Check if the Thermostat
dial has been set towards
the steam range.
Check if the steam regulator
has been set towards
the steam position.
Leaking water Set the thermostat dial
from Soleplate out of steam range.
The heat is still not enough.
The water is over
than max position
Little Steam Check if the steam regulator
is in proper location.
Steam hole or box
is blocked.
Too little water in the box
No Spraying No enough pressure
or air inside
No or little water in the box
After the above-mentioned methods to repair iron, if it still cannot come to work
normally, please send to our special repair agent for repair.
Measurement
Correct Thermostat dial
Button in position.
Adjust the thermostat dial
as per steam range.
Set steam regulator
towards the steam range.
Fill water into the box
Set the thermostat dial
as per steam range.
Open steam button only after
the indicator light goes off.
Pour out the remaining water
Set the steam regulator
to the proper location.
Clean hole with
distilled water.
Fill water into the box
Press the spray nozzle
by hand, and push the
spray button several
times continuously.
Fill water into the box
EN
19