Subaru H001SFN000 Instructions D'installation page 6

6
PRE-ARRANGED JUMPER HARNESS CONNECTIONS, continued
4. Secure the pre-arranged wire harness to the vehicle's
wire harness using two (2) of the supplied 39cm tie
wraps. Trim off the excess tie wraps.
(FIGURE N)
Secure the remote engine start pre-arranged jumper
harness to the vehicle's wire harness using one (1) of
the supplied 39cm tie wraps. Trim off the excess tie
wrap. (FIGURE N)
5. Plug the pre-arranged jumper harness 12-pin connector
into the 12-pin white port on the remote engine start
ECU, previously mounted to the back side of the glove
box inner cover (SECTION 5). (FIGURE O)
ISSUE
PART NUMBER
H001SFN000
DATE
00
1 Jun 2022
FIGURE N
FIGURE O
SUBARU OF AMERICA
6 OF11