Publicité
Les langues disponibles
Les langues disponibles
OIL
Check the oil level every six months. The oil capacity is
about 0.35L. Add fluid as needed. This must be done
with the forks in the lowered position.
Use the hydraulic oil ISO VG 32 or equivalent. Oil
viscosity should be 30cSt at 104°F (40°C).
HOW TO EXPEL AIR FROM THE PUMP UNIT
Air may enter the unit over time or when the seals are
replaced. To expel the air, lift the control lever to the
NOTE: For safe operation of the Heavy-Duty
Pallet Truck, read all warning signs and
instructions here and on the pallet truck prior
to use.
1.
Do not operate the truck unless you are familiar with
it and have been trained and authorized to do so.
2. Do not use the truck on sloping ground.
3. Never place any part of your body in the lifting
mechanism or under the forks or load. Do not carry
passengers.
4. Operators should wear gloves and safety shoes.
Figure 2
PAGE 2 OF 9
MAINTENANCE
DOWN position and move the handle up and down
several times.
DAILY CHECK AND MAINTENANCE
Daily checks of the pallet truck can limit wear and tear
on the unit. Pay special attention to the wheels, the
axles, the handle, the forks and lift and lower control.
LUBRICATION
Use motor oil or grease to lubricate all movable parts.
SAFETY
5. Do not handle unstable or loosely stacked loads.
6. Do not overload the truck.
7. Always center loads on the forks, not at the end of
the forks. (See Figure 2)
8. The capacity of the truck assumes an evenly
distributed load with the center of the load being at
the halfway point of the length of the forks.
9. Make sure the length of the forks matches the length
of the pallet load.
10. Lower the forks to lowest height when the truck is not
being used.
A
B
0522 IH-5484
Publicité
