NUUO NVRsolo Guide De Démarrage Rapide page 3

Step 1: Unpack the Unit
This package contains the following items:
The unit

IR remote control, 1.5M IR extender cable

Two type of screws for 2.5"/3.5"disk drives, SATA cable

[Horizontal] foot pads; [Vertical] Stand, foot pads and screws

12V 4A 48W power adapter, power cord

Warranty card, Quick Start Guide, CD with Install Wizard, Remote Live

Viewer, Playback System, Backup System, Verification Tool and
Offline License Tool application, user manual, and quick start guide
Battery spec is 1.5V, AAA, R03. Two batteries are required for a remote control.
Step 2: Install Hard Drives
Refer to compatibility list and install HDDs. For optimal performance
consideration, install disks with the same model and storage capacity.
The available RAID level depends on the amount of disks installed.
Step 3: Connect the Unit and Devices within the Network
Connect the unit, cameras, and router/switch. If you need to make the
video visible over the Internet, please connect to a "router" with
Internet connection, and the unit will retrieve an IP address through
DHCP by default.
The unit processes built-in DHCP service, which takes the job of router to assign IP addresses, which is
suitable for the pure LAN environment.
Step 4: Connect the Monitor
The unit processes two display interfaces, VGA and HDMI. Connect the
monitor to the unit.
The supporting display resolutions are 1920x1080, 1280x1024, 1280x720, and 1024x768. Please confirm
that one of the resolutions is supported by your monitor.
Step 5: Connect the Power
Press the power button once connecting the power.
1
English