Cinderella FREEDOM GAS NA Manuel Du Produit page 27

5.1 TROUBLESHOOTING TABLE
DISPLAY
ERROR
MESSAGE
Ash container Empty the
should be emptied ash container
Ash container
Toilet locked
must be emptied.
container full
Toilet locked.
No power
Ventilation fan
Error fan
error
Burner fan Error burner
error fan
Malfunctioning
Error hatch
hatch mechanism
mechanism
Ash container
Ash container out
is out of
of position
position
Heating circuit Error burner
interrupted system
Toilet lid sensor is
Lid is open
triggered
Malfunctioning
Error temp
temperature
sensor
sensor
Unreadable / no Unreadable /
display message blank screen
RED YELLOW GREEN
LIGHT LIGHT LIGHT
FLASHING FLASHING STEADY
Alternately Alternately
STEADY STEADY STEADY
ON ON
OFF OFF
FLASHING OFF FLASHING
FLASHING FLASHING FLASHING
STEADY
FLASHING OFF
STEADY
FLASHING FLASHING
STEADY
OFF FLASHING
STEADY
FLASHING OFF
OFF FLASHING FLASHING
SOUND
1 Remove and empty the ash container
3 BEEPS
ON * Toilet must be connected to 230V
3 BEEPS 1 Remove and empty the ash container
10 SECONDS * Toilet must be connected to 230V
ON
APART
1 Make sure that the toilet is connected
OFF
to power, min 11.5 V
1 Check fan for obstructions and ensure
that fan blades are rotating properly
Reset toilet (hold down "Start")
10 BEEPS
2 Open lid until red light flashes, close lid
and press "Start". If error persists, call
support
1 Check fan for obstructions and ensure
that fan blades are rotating properly
Reset toilet (hold down "Start")
10 BEEPS
2 Open lid until red light flashes, close lid
and press "Start". If error persists, call
support
1 If toilet is warm, reset toilet
2 Open lid until red light flashes, close lid
and press "Start"
3 If unsuccessful, reset toilet, insert a
bowl liner and pour 3 cups of water into
10 BEEPS the liner, close lid and press "Start"
ON
4 If unsuccessful wait until the toilet has
cooled (fan stopped) Restart toilet and
5 open lid when the hatch is opening,
remove stuck items manually. If
problem persists, call support
1 Adjust the position of the ash container,
rotate the handle to the left side
2 Check that the stop pin on the container
3 BEEPS is intact
ON
3 Visually check the condition of the
magnet on the container. If problem
persists, call support
1 Reset the toilet and wait 15 minutes.
2 Check that there is gas
3 Check bimetal thermostat on
right-handside of toilet. Unscrew grey
plug and push on fuse inside with
CONTINUOUS finger: do not use any sharp objects
ON BEEPS If the fuse was triggered, you will hear a
click. See section 5.
4 If the fuse was not the problem, restart
toilet and try to start toilet. Repeat a
couple of times. If problem persists, call
support
1 Check the magnet situated inside
NONE the toilet lid and close lid. If problem
ON
persists, call support.
1 Reset toilet
CONTINUOUS 2 Open lid until red light flashes, close lid
BEEPS and press "Start"
3 If failure persists, call support
1 Unplug toilet and wait 5 minutes
2 Plug in toilet and restart toilet
3 If problem persists, call support
ACTIONS
27