Publicité
In case of a new lamp base doesn't fit into the lamp holder, we might
need to conduct a lamp base replacement. Please proceed with the
following procedures,
a) Follow Step 1 and Step 2 (above mentioned)
b) Remove the faulty lamp from the faulty lamp base.
c) Thread thru the wires (2 wires out from a new lamp)
onto the holes (2 holes inside a new lamp base) one by one.
d) After this new lamp is being fully inserted, bend the wires to
upright positions (please cross-reference with other lamps for
details) in ensuring good contacts inside the lamp holder.
CAUTION:
To keep the risk of fire and electric shock to minimal,
1) Only replace lamps with the spare parts provided with this product.
2) Remove the faulty lamp gently and cautiously in avoiding breaking glass.
3) Do not mount this light stings onto trees that are consisting of needles, leaves and/or branches
that are fully or partially covered by metal.
4) Make sure all wires are installed properly so that they are not being damaged by unintentional
cuts or stretches over time.
HOW TO USE THE REMOTE CONTROLLER :
The remote control is for the wired controller only:
(1) REMOVE THE BATTERY LID AT THE BACK OF REMOTE CONTROL, INSTALL THE TWO
AAA/UM4/LR03 BATTERIES( NOT INCLUDED) PROPERLY AS INDICATED ON THE BATTERY
COMPARTMENT. MAKE SURE TO MATCH THE (+) AND (-) ENDS OF THE BATTERIES.
(2) PRESS THE BUTTON TO SELECT DIFFERENT FUNCTIONS, REFER TO "HOW TO USE THE DUAL
COLOR LIGHT CONTROLLER".
(3) TO REPLACE THE BATTERY, OPEN THE BATTERY COMPARTMENT WITH A COIN. REPLACE WITH
TWO AAA/UM4/LR03 BATTERIES.
(4) DISPOSE USED BATTERY PROPERLY. OBSERVE LOCAL REGULATIONS REGARDING DISPOSAL
OF HAZARDOUS WASTE.
(5) ENSURE THE BATTERIES ARE INSTALLED CORRECTLY WITH REGARD TO POLARITY (+ AND -).
IMPORTANT SAFETY INSTRUCTIONS
• WARNING: SMALL PARTS, KEEP AWAY FROM CHILDREN.
• Do not expose light set to moisture.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (Carbon - Zinc), lithium, or rechargeable (NiCd, NiMH or other type)
batteries.
• Remove batteries when not used for an extended period of time, or when depleted.
• Dispose of used batteries properly by following directions on batteries.
• Use only AAA-size (UM4/LR03) batteries for the remote controller.
• Clean the battery contacts prior to battery installation.
• DO NOT DISPOSE OF BATTERIES IN FIRE. BATTERIES MAY EXPLODE OR LEAK.
2 x AAA
Cover
Publicité
