Publicité
IMPORTANT SAFETY
INSTRUCTIONS
When using electrical products, basic precautions should always be followed including the following:
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS BEFORE USE
1. Do not use seasonal products outdoors unless marked suitable for indoor and outdoor use. When
products are used in outdoor applications, connect the product to a Ground Fault Circuit
Interrupting (GFCI) outlet. If one is not provided, contact a qualified electrician for proper
installation.
2. This seasonal use product is not intended for permanent installation or use.
3. Do not mount or place near gas or electric heaters, fireplaces, candles or other similar sources
of heat.
4. Do not secure the wiring of product with staples or nails, or place on sharp hooks or nails.
5. Do not let lamps rest on the supply cord or on any wire.
6. Unplug the product when leaving the house, when retiring for the night, or if left unattended.
7. This is an electric product-not a toy! To avoid risk of fire, burns, personal injury and electric shock
it should not be played with or placed where small children can reach it.
8. Do not use this product for other than its intended use.
9. Do not hang ornaments or other objects from cord, wire or light string.
10. Do not close doors or windows on the product or extension cords as this may damage the wire
insulation.
11. Do not cover the product with cloth, paper or any material not part of the product when in use.
12. This product is equipped with push-in type lamps. Do not twist lamps.
13. Read and follow all instructions that are on the product or provided with the product.
SAVE THESE INSTRUCTIONS
14.
Use and Care Instructions
1. Before using or reusing, inspect product carefully. Discard any products that have cut, damaged,
or frayed wire insulation or cords, cracks in the lamp holders or enclosures, loose connections or exposed
copper wire.
2. When storing the product, carefully remove the product from wherever it is placed, including trees,
branches, or bushes, to avoid any undue strain or stress on the product conductors, connections,
and wires.
USER SERVICNG INSTRUCTIONS
Lamp Replacement:
Step 1:
Disconnect the
unit from the outlet (During
unplug, grasp the plug
instead of pulling on the
cord for protecting the cord
from damage).
Step 2:
Release locking
tab, pull out the lamp
(together with lamp
based) from the lamp
holder.
Step 3:
Place a
replacement lamp
included in the product
(3.6V/0.072W or
2.4V/0.048W LED type
lamps) into the lamp
holder and tab closed.
(Reference figure only)
Publicité
