BGS technic 8066 Mode D'emploi page 4

Les langues disponibles

INTENDED USE

This brake bleeder is used for quick and easy bleeding of brake and clutch systems by one person.

The brake fluid flows directly into the collection container when bleeding, thus ensuring a clean work

area. Old brake fluid can be sucked out of the reservoir with the help of the rigid hose.

INSTRUCTION

1. Connect the professional brake bleeder to the compressed air supply.

Note: Do not operate the brake pedal while bleeding the brake.

2. Apply bleeding adapter to the nozzle on the brake caliper respectively on the wheel cylinder and

open the nozzle slowly. Note: When opening the nozzle too far, surrounding air might be sucked

into the system via the nozzle thread. When opening the nozzle not far enough, the brake fluid

might not flow well or maybe not at all.

3. By activating the bleeder's trigger you create a vacuum and the brake fluid will be sucked into the

drain canister. Note: When working on vehicles with a load-dependent brake system on the rear

axle, the brake fluid might not flow well or maybe not at all. In this case follow the manufacturer's

advice.

4. As soon as the brake fluid flows bubble-free through the clear hose, close the nozzle and take off

the bleeding adaptor.

5. Repeat these steps on each brake caliper or wheel cylinder. Note: While bleeding the brake, there

must be a sufficient amount of fresh brake fluid in the refilling canister. Otherwise air will be

sucked into the brake system and you will have to bleed the brake again.

6. Check the filling level in the brake fluid reservoir of your vehicle after finishing the bleeding and

refill if necessary. Close and seal the reservoir and check all nozzles for impermeability.

CARE

We recommend a thorough cleaning after each use.

ENVIRONMENTAL PROTECTION

Recycle unwanted materials instead of disposing of them as waste. Packaging should be

sorted, taken to a recycling centre and disposed of in a manner which is compatible with the

environment. Contact your local solid waste authority for recycling information.

NOTES

BGS technic KG

Bandwirkerstr. 3

D-42929 Wermelskirchen

Tel.: 02196 720480

Fax.: 02196 7204820

mail@bgs-technic.de

www.bgstechnic.com