Publicité
Les langues disponibles
Les langues disponibles
Installing Accessories
-
Press and hold the spindle lock (A), and rotate the shaft by hand until the spindle
lock engages the shaft, preventing further rotation.
-
With the spindle lock engaged, use the collet wrench (E) to loosen the collet nut
(D), if necessary.
Insert the shank of the accessory into the collet.
-
-
With the spindle lock (A) engaged, tighten the collet nut (D) with the provided
wrench (E) until the accessory shank is gripped by the collet. Avoid excess
tightening of the collet nut (D).
Removing Accessories
-
With the spindle lock (A) engaged, loosen the collet nut (D) with the provided
wrench (E).
-
Remove the accessory.
Using Mandrels
The most common types of the mandrel to use with this tool are the standard
mandrel which is used with cutoff
discs, grinding wheels, emery wheels, and cut-off wheels. Screw mandrels are used
with polishing wheels
and polishing drums. The drum mandrel is used with sanding drums.
To install:
-
Install the mandrel.
If using the standard mandrel:
-
Press and hold the spindle lock (A).
-
Insert the slot end of the provided wrench into the slot on top of the mandrel and unscrew.
Fig.5
- 14 -
A
Fig.6
C
D
Publicité
