Publicité
Active USB 3.0 Extension Cable
EN
Câble D'extension USB 3.0 Actif
FR
• Do not modify product and accessories.
• Do not short-circuit connectors and circuits.
Do not operate a device if it is not in working order. In such
cases, it must be secured against unintentional further use.
• Use product, product parts and accessories only in per-
fect condition.
• Avoid stresses such as heat and cold, moisture and di-
rect sunlight, microwaves, vibrations and mechanical
pressure.
• In case of questions, defects, mechanical damage, trou-
ble and other problems, non-recoverable by the docu-
mentation, contact your dealer or producer.
Not meant for children. The product is not a toy!
• Secure packaging, small parts and insulation against
accidental use.
Tripping hazard
Risk of injury by stumbling and falling.
• Route the cable safely.
• Install the system and devices attached to it in a way
that persons cannot be injured, or objects not be dama-
ged for example by dropping or stumbling.
Heat accumulation
• Do not cover the product.
• Keep enough space around all devices for a good vent-
lation and free motion and to avoid damages.
2 Description and function
2.1 Product
The product is an active USB extension and is used to ex-
tend and amplify a USB connection by 5 m. It supports
USB 1.1, 2.0, 3.0 and works via Plug & Play without exter-
nal power supply. The product is 1x cascadable, so 2 USB
extensions can be connected for a total length of 10 m.
2.2 Scope of delivery
Active USB 3.0 Extension Cable, User Manual
2.3 Operating Elements
See Fig. 1.
1 USB-A 3.0 socket
3 Intended use
This product is intended exclusively for private
use and its intended purpose. This product is not
intended for commercial use. We do not permit
using the device in other ways like described in chapter
„Description and Function" or in the „Safety Instructions".
Use the product only in dry interior rooms. Not attending to
these regulations and safety instructions might cause fatal
accidents, injuries, and damages to persons and property.
4 Preparation
1. Check the scope of delivery for completeness and in-
tegrity.
2. Compare the specifications of all used devices and en-
sure compatibility.
5 Connection and operation
See Fig. 2.
1. Connect a signal source to the USB-A 3.0 socket (1) of
the USB extension cable.
You can also connect two USB extension cables to each
other. Signal transmission is possible over a total length
of max. 10 m.
2. Connect an output device (e.g. PC) to the USB-A 3.0
plug (2) of the USB extension cable.
3. Wait until the device has been recognised.
4. Remove connected devices after use via the „Safely
Remove Hardware" function.
5. Disconnect the cable connections.
REV2023-03-15
Subject to change without notice. |
V3.0rs
Sous réserve de modifications.
2 USB-A 3.0 plug
6 Maintenance, Care, Storage and
Transportation
The product is maintenance-free.
NOTICE!
• Only use a dry and soft cloth for cleaning.
• Do not use detergents or chemicals.
• Store the product out the reach of children and in a dry
and dust-protected ambience when not in use.
• Store cool and dry.
• Keep and use the original packaging for transport.
7 Disposal instructions
7.1 Product
According to the European WEEE directive, electri-
cal and electronic equipment must not be disposed
with consumers waste. Its components must be re-
cycled or disposed apart from each other. Otherwi-
se contaminative and hazardous substances can damage
the health and pollute the environment.
As a consumer, you are committed by law to dispose elect-
rical and electronic devices to the producer, the dealer, or
public collecting points at the end of the devices lifetime for
free. Particulars are regulated in national right. The symbol
on the product, in the user manual, or at the packaging all-
udes to these terms. With this kind of waste separation, ap-
plication, and waste disposal of used devices you achieve
an important share to environmental protection.
WEEE No: 82898622
7.2 Packaging
Packaging can be disposed of free of charge at the
suitable collection points – paper belongs in paper
bins, plastics belong in yellow sacks and glass be-
longs in used glass bins.
DE4535302615620
8 EU Declaration of conformity
With the CE sign Goobay®, a registered trade-
mark of the Wentronic GmbH ensures, that the
product is conformed to the basic European
standards and directives.
1 Consignes de sécurité
Le mode d'emploi fait partie intégrante du produit et com-
prend d'importantes informations pour une bonne installati-
on et une bonne utilisation.
• Lisez le mode d'emploi attentivement et complètement
avant de l'utiliser.
Le mode d'emploi doit être disponible à des incertitudes et
transfert du produit.
• Conservez soigneusement ce mode d'emploi.
• Ne pas ouvrir le boîtier.
• Ne modifiez pas le produit et les accessoires.
• Pas court-circuiter des connexions et circuits.
Un appareil défectueux ne doit pas être mis en service. Il
doit au contraire être protégé contre toute utilisation invo-
lontaire.
• Utilisez le produit, pièces et accessoires des produits
uniquement en parfait état.
• Éviter des conditions extrêmes, telles que la chaleur ex-
trême et froid, l'humidité et de la lumière directe du so-
leil, ainsi que microondes, des vibrations et de la pres-
sion mécanique.
• En cas de questions, les défauts, les dommages méca-
niques, des ingérences et d'autres problèmes, non ré-
cupérables par la documentation, contactez votre re-
vendeur ou le producteur.
Non destiné à des enfants. Le produit n'est pas un jouet !
• Sécuriser l'emballage, petites pièces et l'isolation contre
l'utilisation accidentelle.
Risque de trébucher
Risque de blessure en cas de trébucher.
• Pose de câbles en toute sécurité.
- 3 -
Pillmannstraße 12 | 38112 Braunschweig | Germany
95727
Material damage
Goobay® by Wentronic GmbH
Publicité
