Publicité
2 Mount the Wall Plate
Wood stud
2-1 Locate studs
2-2 Mark the wall
2-3 Drill pilot holes
2-4 Tighten lag bolts
[08]
[07]
6903-002002 <05>
All manuals and user guides at all-guides.com
< 16 mm
(5/8 in.)
[03]
[03]
Verify the center of the stud using an awl, a thin nail, or an edge to
edge stud fi nder.
CAUTION:
Avoid potential personal injuries and property
damage!
Any material covering the wall must not exceed 16 mm (5/8 in.)
Minimum wood stud size: common 51 x 102 mm (2 x 4 in.)
nominal 38 x 89mm (1½ x 3½ in.)
For assistance in determining wall plate location, see Mount Wizard at
simplicityav.com.
Level the wall plate [03] and mark the hole locations.
CAUTION:
Avoid potential injuries or property damage! Pilot
holes MUST be drilled to a depth of 75 mm (3 in.) using a 5.5 mm
(7/32 in.) diameter drill bit.
75 mm
(3 in.)
CAUTION:
Improper use could reduce the holding power of
the lag bolt. To avoid potential injuries or property damage:
DO NOT over-tighten the lag bolts [07].
Tighten the lag bolts [07] only until the washers [08] are pulled
fi rmly against the wall plate [03].
13 mm
5.5 mm
(1/2 in.)
(7/32 in.)
9
Publicité
